Please find details in tender documents. The brif details are:

1-Remove the
shingles from the low slope roof of the addition. The removal of the shingles
should start at the bottom edge of the low slope roof and go all the way to the
roof ridge of the main roof.
2-Remove all the roof sheeting from the low slope
roof of the addition.
3-Remove all the existing insulation from the open
portion of the roof.
4-Remove the entire interior drywall from the ceiling of
the addition.
5-Install a new vapor barrier to the ceiling; seal all
penetrations in order to achieve a completely sealed ceiling area.

6-Construct and frame a new roof over the addition.
7-The new construction
shall provide space for the installation of a minimum of an R-40 value of loose
insulation and provide a minimum of 10 to 12 inches of open air space above the
insulation.
8-Install new plywood roof sheeting to the new roof
structure.
9-Install a layer of Ice and Water Shield membrane to the new roof
bottom edge.
10-Install a layer of 15 LB tar roofing paper to the remaining
exposed plywood sheeting.
11-Install aluminum roof edge to the new roof; color
to match existing roof edge.
12-Install new roof shingles and tie to the
existing roof shingles at the ridge.
13-Install new metal step flashing were
required.
14-Extend plumbing vents were required.
15-Fascia boards should be
covered with aluminum fascia; color to match existing.
16-The new roof shall
have a minimum of 10 inches of overhang.
17-Install matching wood siding to
the gables of the new roof structure, stain siding to match existing
color
18-Install two (2) 10 inches by 10 inches gable vent complete with
louvres and screen.
19-Install new drywall to replace the sheetiNorman Wells, NT
Submissions addressed to Technical Advisor, NWTHC Sahtu District, #4 Caribou
Crescent, P.O. Box 429, Norman Wells NT X0E 0V0 will be received until:
3:00PM, Local Time, June 3, 2015
Security required as specified in tender documents
NWTHC Norman Wells
Submissions will be opened at 3:01PM June 3, 2015 at: NWTHC Norman Wells

General Enquiries to:
John Kivi
Technical Advisor
Sahtu District Office
Phone: 867-587-5116

Technical Enquiries to:
Guy St Andre
PO Box 429, Norman Wells, NT, X0E 0V0
867 587 5100
867 587 5101

The GNWT Business Incentive Policy will apply to this procurement.
Chapter 5 of the Agreement on Internal Trade will apply to this procurement.

Norman Wells, NT