Note: Materials is to be delivered to the project loacation in Fort Good Hope
prior to March 31, 2015.

1-Remove the existing front landings and
stairs.
2-Build and install two new landings complete with stairs and
railings. The new landings shall be the same size as the original
landings.
3-Stain all lumber with one coat of exterior Latex stain color(Blue
Nose) # CC-800 by Benjamin Moore Paint prior to assemble any components. All
railing upright parts shall be stained with 2 coats of exterior stain color
white. Once the entire landing and stairs have been completely built a second
coat of stain can be applied. All cuts have to be stained.
4-Pressure treated
wood pads complete with treated cuts have to be installed on the ground to
support any posts and stair case. Pads shall be built using 3 layers of
pressure treated 2 x 6 lumber only. Pads size shall be a minimum of 24” by
24”.
5-Check and repair all fascia and soffit components. Stain all to match
existent.
6-Stain all corner boards with two coats of exterior stain to match
existent.
7-Repair all existing skirting, install new were skirting is missing
and stain all with two coats of exterior stain throughout. Color to match
existing.
8-Replace all exterior lights with new light fixture matching
existing light fixtures.
9-Check and ensure all exterior receptacles are
operating as intended, ensure weather proof covers are in place.
10-Repair and
make good all eaves through system troughout.
11-Repair and re install the
attic access covers.
12-Remove all exterior doors complete with
jamb.
13-Install new exterior doors complete with new door jamb, door hardware
and dead bolt where applicable.
14-60: Please refer to contract documents.

Fort Good Hope